Your garage door has two overhead springs some doors have the springs on the side called extension springs that are responsible for opening and closing the door.
Garage door opens unevenly.
If there is a little gap at the bottom of your garage door on one side or your garage door has been jerking back and forth it s probably because there s uneven tension from the springs.
Step ladders move the garage door up and down until you find a place where the door stays suspended when you let go.
Who knew you and your garage door could have so much in common.
This will cause the unit to stick.
When this unusual problem occurs it means the up limit switch probably needs to be moved away from the motor unit.
If the opener is adjusted properly the garage door will move up and down in an even motion.
If that point is more than four feet or less than three feet above the ground you will need to balance the door.
How to adjust a garage door that is uneven step 1.
One of the most likely culprits when you have a crooked garage door is a broken torsion spring.
If it happens at all it will usually be noticed when you first install the garage door opener.
Garage door opens but the motor won t stop running.
There are two types of springs.
Torsion and extension springs.
I would disconnect the garage door opener from the scenario and work on getting the door to operate nice and smoothly.
It is possible that the.
Check that it is straight.
Push the door push the door back to adjust the door and get the center aligned again.
It is rare for this problem to suddenly appear.
If it s binding if you feel like it s binding or uneven without the garage door opener attached to it then that s the heart of the problem right there.
Pulling the door up and down is a garage door opener.