Garage Door Opener Has To Be Force Closed

If your opener is more than five years old it was most likely programmed with a specific amount of force needed to pull the garage door up.

Garage door opener has to be force closed.

If when closing your door its bottom edge contacts the floor and then reverses direction and raises again you will need to adjust your close force. If an operational problem exists and the garage door opener will not close the opener can be forced to close. When the garage door is closing and it doesn t reach the fully closed position it assumes there is an obstruction in the way and then it reverses. You are overriding the infrared beam sensor when you hold down the wall button continuously while the garage door is closing.

Press and hold the wall console button until the garage door is completey closed. Check the space under the bottom door edge to be sure it is tight against the floor surface. Garage door openers have an adjustment screw that controls the closing force the pressure with which a door is allowed to descend before the motor switches off. Open the garage door using the garage door opener.

When the garage door opener is first installed it is programmed to learn the fully open and fully closed position and then it stores it to memory. Any transmitter like a handheld clicker or outdoor keypad will also not work to close the door if there is a problem with the sensor. Over time that amount of force needs to be increased to. Check for interference from adjacent photo eye sensors of any brand.

The garage door should reverse direction when you apply force to the handle with your. Adjust your door opener limit switch. Door starts down then stops before it is closed. Tuesday june 26 2018.

2 close the garage door while holding onto the door handle.